← Ice Ice Hammer StudioGUITAR ROOM

Plug in. Shape your tone.

Record your own electric guitar, try your amp captures, or start a guitar idea with AI.

Connect your guitar to a USB audio interface, then connect the interface to this device.

01 · Guitar input

MOMIX CAB and other USB interfaces appear using the names supplied by your device. Compatibility and delay depend on your browser, interface, and operating system. Use wired headphones; begin with low volume.

Input disconnected

Input access starts only when you enable it. Monitoring is off initially. If your interface also plays the dry input directly, hearing both paths can cause an echo; adjust its direct-monitor control if available.

02 · Amp models and cabinet

Load up to 12 .nam files and switch between them. Files stay on this device. Keep each creator’s attribution and license with your downloads.

No amp capture loaded. Clean / bypass records your original input.

Find amp captures on TONE3000 ↗ · Engine credits and licenses

Virtual pedalboard

Boost → compressor → overdrive → amp → tone EQ → cabinet IR → chorus → delay → reverb. Enable pedals individually; set boost and reverb to zero to bypass them. Stop recording before changing the chain.

03 · Record or re-amp

Each recording preserves a clean take and a separate processed take. Download both before leaving. Maximum take length: three minutes. These takes are not saved to your account automatically.

To layer a take over a song, download its WAV, open that song’s workbench, and choose “Add audio track.”

04 · Generate electric guitar

Review the model and credit cost in Studio, then press Create. AI generation does not guarantee an isolated guitar stem. This does not use your connected interface.